If you’re wondering how to get the spare tire off your Ford F150, then you’re in luck! This video from 1a auto shows you how to do just that. The tips in this video also apply to the older F150 models, including the 2011 model. Just follow these steps and you’ll be ready to go! But, before you get started, make sure you know how to get the spare tire off your truck!
The first step is to remove the locking device on the spare tire. This locking device can be reached using a pair of joint pliers. The next step is to insert a piece of wood into the gap between the tire and the truck bed frame. It’s a good idea to use a pair of pliers to get this part, but it’s not necessary to buy one.
Next, insert the ignition key into the keyhole on the rear bumper. You should then unscrew the jack handle and unlock the spare tire access cap. Then, insert the wheel holder into the wheel holder through the center bore of the bad wheel. Once the holder is positioned, push the cable upward until the tire holder is level with the wheel. Once the tire holder is secure, rotate the jack handle or tire iron to raise the bad wheel.
How Do You Get the Spare Tire Off a 2012 F150?
The 2012 Ford F150’s spare tire is stored underneath the truck’s bed and uses a pulley mechanism to raise and lower itself. To get the spare tire off, you’ll need a floor jack and some other tools. Most of these tools are located underneath the bench seat or behind it. The back seat may also have to be raised and removed. If the spare tire is attached to the wheel hub, you’ll need to remove the trim covers from it.
First, remove the lock cylinder from the bumper access hole. Then, insert the jack handle into the guide tube, following the instructions on the side of the bumper. Make sure to fully insert the handle through the bumper access hole, then turn the jack handle counterclockwise to lower the tire. The cable must be slack, so that the tire can slide rearward. Next, remove the tire retainer from the center of the wheel.
How Do You Get the Spare Tire Off a 2015 F150?
In order to remove the spare tire from your 2015 Ford F150, you must first disengage the car’s ignition and unlock the spare tire access cap. Next, you will need to remove the spare tire access cap from underneath the truck and place it in the back of the vehicle. After that, you can push the spare tire carrier cable through the tire iron. Finally, you must insert the jack into the tire holder located under the bumper.
To remove the spare tire from your truck, you first need to locate the wheel lock key. This key can vary by model year. You can find it attached to your ignition key or a separate key that works in a similar manner. Once you locate the key, insert it into the lock’s opening and crank it to lower the tire. The more cranking you perform, the lower the tire will be. If you have any questions, you can check out Coldlakefordtube’s video to get a complete step-by-step guide.
Where is the Jack And Lug Wrench on a Ford F150?
The Jack and Lug Wrench are located on the left side of the truck. They can be found next to the spare tire. To remove the wheel, unscrew the lug nuts by turning them one-half counterclockwise and then pull them out. When removing the wheel, be sure to jack the truck up at the designated locations to prevent damage to the vehicle. To determine where to jack up your truck, look for small arrow-shaped marks on the sills.
The Ford F150 comes equipped with a spare tire that is slightly smaller than the original tire. If you need to change a tire, make sure to follow the steps in your owner’s manual. First, make sure your vehicle is parked level and the engine is off. If possible, remove the passengers and jack the truck from the back seat. Unhook the straps that hold the jack in place.
How Do You Get a Spare Tire Off?
First, you will need to unplug the spare tire’s locking pin. To do so, remove the key from the ignition and insert it into the keyhole on the rear bumper of the truck. Then, remove the spare tire access cap from the truck bed. Insert a pry bar or vice grip into the socket and turn counterclockwise. The tire should then fall out of the truck bed.
The next step is to locate the drop mechanism. There is a long black plastic pipe next to the tire. Pull it toward the rear to uncover the drop mechanism. Next, insert the wood or a piece of wood into the gap between the tire and the bed frame. It may be helpful to have a helper to get it into the right place. If the wood is too large, you may need to push or pull it from the backside of the tire.
The procedure for changing the spare tire varies according to the vehicle. Read the Owner’s Manual to get instructions and safety tips. To get started, turn off the engine, set the hazard lights, and activate the parking brake. Once you have the spare tire out of the way, simply drive your truck to a nearby dealership to get a new permanent tire. Although spare tires are meant to be temporary, they are still useful and should be used as needed.
How Do You Change a Tire on a 2018 Ford F150?
The first step in changing a tire on a 2018 Ford F150 is to pull over to a level area, preferably the side of the road. Identify the spare tire (typically located in the trunk or liftgate), and grab the owner’s manual. If possible, get the spare tire and place it diagonally opposite the flat tire. Then, put on the emergency brake or parking brake.
Once the tire has inflated to the proper pressure, you’ll need to rotate the tires to prevent them from wearing out prematurely. The default tire rotation interval is five thousand to 7,000 miles, though different cars may require a different mileage. The front tires on your 2018 Ford F150 are likely to wear out faster than the back ones. To ensure proper tire rotation, rotate your tires on a regular basis.
You’ll need to use a jack stand. The jack stands are important for many automotive procedures, including changing a tire. Using the jack stand to place your vehicle on is both simple and dangerous. Don’t forget to use the spare tire jack on jack points highlighted in the manual. If you don’t have a spare tire jack, use a real jack.
How Do You Change a Tire on a 2021 Ford F150?
If you have flat tires, you might have to change them yourself. There are several easy steps to change a tire on your 2021 Ford F150. First, jack up the truck. Locate the arrow that indicates where to place the jack. Once the jack is placed correctly, loosen the lug nuts. Once loose, remove the lug nuts. Then, slide the spare tire onto the vehicle.
Next, determine the tire’s air pressure. Low tires do not have enough air pressure. The recommended tire pressure is listed in psi on the sidewall. Find this number inside the driver’s door. Under-inflated tires can cause flat tires or blowouts. If you notice the TPMS light on your dashboard, the tire is either under-inflated. To remedy this, add air to the tire until it reaches the recommended air pressure.
If you’re unsure of how to change a tire, you can take the wheel off the vehicle and inspect the area. If you notice a puncture, you should replace the tire. Make sure that the puncture is a small one, and that the tread is no more than 2/32 inches thick. Moreover, larger punctures, such as those in the sidewall, will not be repaired. If the tire has significant cuts, you need to replace it completely.
How Do You Remove the Spare Tire on a 2016 F150?
If you’ve ever wondered how to remove the spare tire on a Ford F150, you’re not alone. There are a number of tips and tricks to keep you safe on the road. Here are a few of the most common, and simplest, steps. Start by turning off your vehicle’s ignition. If the spare tire is in the back of the vehicle, unlock the wench hole in the rear license plate frame with the key.
To remove the spare tire, lower your vehicle to the ground. To do this, you can either get a jack kit at your local hardware store or from Amazon. Once you have your tools, you can lower the spare tire. Make sure you don’t drive the vehicle while lowering it. Experts recommend not changing tires on a slope. This is because your vehicle will likely tip backwards as you remove it.
Next, locate the spare tire, which is located under the bumper and behind the tow hitch bar. Press your hand against the bulge to confirm that it is the spare tire. Once you’ve located it, use the ignition key to release the plastic cover. You can then replace the spare tire assembly. If you are unsure of the procedure, a video by Coldlake Fordtube demonstrates all steps.
Learn More Here:
4.) F150 History